15
If the temperature of the ICE MAKING water supply is too high, the amount of ICE MAKING
may be reduced, If the water pressure is too low, it may not be possible to freeze.
In this case, an auxiliary hydraulic pump should be installed.
[ Connection of water and drainage hoses ]
Division
Proper water temperature
Water pressure
Hose to be used
ICE MAKING water supply
50 ~ 90 ℉
20-80 psi
NPT 3/8"
ICE MAKING drainage
-
-
NPTF 3/4"
1.97" or more
Drain floor level
Ice-maker drain outlet
Connection method of water supply and drainage
Please connect with an inner diameter of Ø0.78" or more for the ice making
drain hose and the drain outlet should be 1.97" above the drain floor level.
(If the drain outlet dip in the drainage, the drainage may flow back into the ice maker
and damage the product and the floor.)
※ After the installation is complete, please operate the product and check whether
there is leakage in the water supply and drainage parts.
Be careful not to bend the drainage pipe during
the installation and also confirm that the pipe is not
exposed to fire or sharpness which may result
in the drain burst.
(This will become the cause of the PL accident
and the manufacturer shall not be held responsible.)
Water
connection
