Step 2:
Mount the bin-stat.
Installation Steps
30” Models
Drill a ½” hole through the back of the
ice machine, below the power supply.
Mount the bin-stat control to the back of
the ice machine by drilling two 3/16”
holes through the back panel and
fastening it with the provided screws.
It will be easier to first place the bin-stat
control on the back of the machine to
mark/drill the holes from the back side of
the machine.
Do NOT drill through the holes on the bin-
stat control as they are threaded!
Bulb hole is 5-
¾” down from top & 1
-
¼” from side.
First bin-stat hole is 10-
¼” down from top & 1
-
¼” from side.
Second bin-stat hole is 2-
Τ
3
16
“
down from first hole.
For IM-1100, ALL holes must be 1-
Τ
𝟕
𝟖
“
from the side.
6
