Step 2:
Mount the bin-stat.
Installation Steps
22” Models
Drill a ½” hole through the back of the
ice machine, next to the compressor for
the sensing bulb to exit the machine.
Mount the bin-stat control to the inside, back panel
of the ice machine by utilizing the existing screw to
the left of the power cord, and then drilling one
3/16” hole below that, through the back panel, and
fastening it with the provided screws.
It will be easier to first mount the bin-stat control on
the back of the machine, utilizing the existing screw
mentioned above, and then marking/drilling the
second hole from the back side of the machine.
Do NOT drill through the holes on the bin-stat control
as they’re threaded!
Bulb hole is 15-
Τ
3
8
"
down from top & 1-
¼” from side.
Second bin-stat hole is 2-
Τ
3
16
“
down from first hole.
7
