10
5. Installation Requirements
Do not install the product
near the heat generating
source.
It may cause a fire.
Do not install the product
in a humid, dusty, or water
(e.g. rain) splashing place.
It may cause an electric shock or fire.
Do not install the product near
combustible gases
or inflammable materials.
It may cause a fire.
When moving the product,
be careful not
to slip and fall.
It may cause an injury or
product damage.
Do not forcibly apply force or
shock to the product.
It may cause damage to the product.
This product is for indoor use
only. So install the product
inside the house.
Caution!
This product is for indoor use only. So do not install the product outdoors. Inevitably, when
the product is installed outside, prepare a shade to block direct sunlight, rain, wind, and dust
for sanitary control and optimal performance. Install the product in the place where you can
easily manage it to prevent robbery and loss by dangerous play.
Keep at least 30 cm distance
for the side and rear of the
product.
Do not install the product
on a weak or uneven floor.
It may cause vibration and noise.
Adjust the vertical balance of
the product not to shake and
then adjust the horizontal
balance.
Firmly fix the product.
The drain hose is located
on the top of the drain box.
Check any damage of the
product.
If found, contact the delivery agency
to request claims on it.
Summary of Contents for SSM- 420
