19
The site sterilization can be performed additionally after parts sterilization but it cannot
replace the parts sterilization.
①
According to the food safety regulations and manufacturer specification, prepare
five liters of warm (45 to 60
℃
) sterilization solution (remaining chloride 100 ppm).
②
Fill the solution in the canister.
③
Use the proper brushes to wipe the surfaces projected above the solution level
and the lower area of the canister cover with the solution.
④
Attach the canister cover and operate the product for mixing the solution for about
two minutes. Drain the solution from the canister.
⑤
Use fresh material to remove the remaining sterilization solution on the surface of
the canister. Afterwards, do not rinse the product.
⑦
Use fresh material to remove the remaining sterilization solution on the surface
of the canister.
Afterwards, do not rinse the product.
7.3.5 Sterilizing the site
⑥
Push the canister fully into the canister to fix in the
packing cushion and fixing latch.
(See Figure 14).
(Figure 14)
Caution
To reuse the product after a long time, paint the packing cushion with edible grease as in
⑤
. Otherwise, noise may be heard from the product.
For correction, you have to get a charged service.
Summary of Contents for SSM- 420
