51
batteries. (Or the display will blink once to indicate the end of setting and the current
cannot be changed afterward.)
It may take up to several days to finish the refreshing process, depending on the selected
discharging current.
The maximum refresh current is 1000 mA and not affected by the number of
rechargeable batteries inserted.
TEST MODE
In Test mode the rechargeable batteries will first be fully charged and then discharged to
determine the capacities. Finally, the rechargeable batteries are charged up again and the
capacity in (mAh) of (Ah) will be estimated and shown after the discharging ends.
By pressing the MODE key within 8 seconds after inserting the rechargeable batteries, the Test
mode can be selected. (The mode key shall first be pressed and held for 1 second to activate
the mode change. The subsequent pressing of the mode key will enable to toggle between the
“Charge”, “Discharge”, “Test” and “Refresh” mode.)
Summary of Contents for Battery Charger
