DX8
Dual Balance Charger/Discharger/DC Power
- 11 -
1.
Channel Mode
has
asynchronous
,
synchronous
available, see more details on
2. If select
synchronous
mode, the maximum charge/discharge current setting will change from 30A to 50A.
3. If tick
Auto saves before the program runs
, the parameters set on the
Run program
will be saved automatically, and
the Run Program will display “
Auto save
” ( shown in the following left picture), otherwise it will display “
Don’t save!
”
(shown in the following right picture); for the built-in program, the Auto save before the program runs option is ticked
by default.
Run Program for Charger
After selecting program on
MEMORY SELECTION
,
click to enter
Run Program
interface (press
<STOP/START-x>
on
the initial interface will enter
Run Program
from the last running program), as below:
1. The revised common parameters of built-in program will be saved by default automatically after running, while the
program customized by the user can be set to be saved or not in
MEMORY SETUP→MEMORY OPTION→Auto save
before the program runs.
2. After setting the
Cap.
value, when the Current value exceeds the certain value, the system will show a warning and
alarm. The Current value of each battery type is: LiXX battery > 3C, NiMH/NiCd battery > 2C, Pb battery > 0.3C, NiZn
battery>2C.
3.
Turn
<
>
to choose
Run Program
, the common parameters are in grey, which is inalterable; if needs to change, the
user can long press
<
>
, as below:
1
.
Run Program Selection
2
.
Common Parameters Setup
3
.
Auto-save Hint
Channel Mode:
Asynchronous (default); Synchronous
Auto save before the program runs:
if ticking, the
modified parameters will be saved automatically;
default: ticking
Run Counter:
0-999; default: 0
Log Interval:
0.5-60Sec; default: 1Sec
Log save to SD card:
If ticking, the Log will be saved to SD card
1
2
3
