General information
6
m
IMPORTANT
–
Avoid contact with the non-insulated parts of the equipment during its operation. When adjustments or checks are carried
out during operation, it is necessary to protect oneself with suitable clothing (P.P.E. according to Italian Legislative Decree
81/08).
–
Climb up and down the top of the boiler body to perform ordinary and extraordinary maintenance operations using PPE
according to the Regulations in force in the Unit Installation Country.
–
Pay attention to sharp edges on the generator and its accessories.
–
The boiler must be kept sheltered from adverse weather conditions, with regard to the minimum temperature (-10 ° C) and
from the rain.
–
The user is responsible for considering the seismic degree of the user area in the design of the heating plant.
–
After an earthquake, have technical personnel assess any damage by carrying out NDCs (non-destructive checks), if
necessary.
–
The manufacturer shall not be held liable in the event of accidents caused by incorrect decommissioning.
–
The personnel in charge must be able to prove to have sufficient knowledge and experience relating to the safety and
control / regulation accessories supplied with the generator and good familiarity with the instructions contained in the use
and maintenance manual and be capable and physically suitable.
–
During handling, always maintain a distance of at least 5 m from the projection of the appliance to the ground
–
In case of violent impact during handling, visually check the integrity of the appliance, all over; run the hydraulic test again.
–
For any downgrading, comply with what specified in the Regulations in force in the Unit Installation Country.
–
Boiler design takes into account only the loads due to static internal pressure, temperature, equipment weight in operating
conditions (static load), weight in test conditions (static load), boiler support connection.
–
In order to limit boiler operating cycles, it is started at pressures below 0.5 barg.
PROHIBITIONS
d
IT IS FORBIDDEN
–
Operate electrical devices or appliances such as switches, household appliances, etc. if you smell fuel or unburnt materials.
In this case:
-
ventilate the room by opening doors and windows
-
close the fuel shut-off device
–
Perform any technical or cleaning intervention before disconnecting the appliance from the electrical power supply and
wearing the Personal Protective Equipment (P.P.E. according to Italian Legislative Decree 81/08).
–
Modify the safety or adjustment devices without the steam generator manufacturer’s permission and instructions.
–
Plug or dimensionally reduce the ventilation openings of the installation room. The ventilation openings are essential for
proper combustion.
–
Perform any welding/repairs. If necessary, contact the manufacturer/verifying party for operation (in Italy according to MD
329/04).
–
Expose the generator to atmospheric agents.
–
Leave flammable substances and containers in the room where the appliance is installed.
–
Use generator fittings as pipe supporting points.
–
Disperse the packaging material in the environment and leave it within the reach of children as it may be a potential source
of danger. It must be disposed of in accordance with the legislation in force.
–
An improper use of the system.
HAZARDS
a
DANGER
–
Dangers due to
water leaks
. Disconnect the boiler from the electrical power supply, close the water supply and promptly
contact the Technical Assistance Service Authorised
ICI CALDAIE S.p.A.
or professionally qualified personnel.
–
Danger of explosion.
Routine and extraordinary maintenance must be entrusted to
professionally qualified personnel
with the purpose of promptly detecting any damage to the generator's pressurised body and the safety and control
accessories.