Residual Risk Management
37
HOT SURFACES
–
Avoid contact with generator uninsulated parts during operation. Should adjustment or check activities be carried out during
operation, the operators must wear suitable protective equipment (gloves, shoes and thermal coverall).
–
Protection with suitable clothing (PPE in compliance with the prevailing laws).
–
Insulation with glass wool or refractory materials in general of the parts that can come into contact with hot surfaces during
standard use and maintenance conditions.
–
Use of warning signs to be affixed on hot surfaces.
SHOCKS AND ACCIDENTAL FALLS
–
Anti-slip embossed upper walk-on platform.
–
Climb on or off the roof to carry out ordinary and extraordinary maintenance operations using a suitable ladder and anti-slip
shoes.
–
Pay attention to sharp edges on the generator and its accessories.
MINIMUM TEMPERATURE
–
Make sure that the temperature the boiler can be subjected to complies to the design minimum permitted temperature.
ATMOSPHERIC CONDITIONS
–
Protect the generator against adverse climatic conditions.
INSTALLATION
–
Make sure that hydraulic connections are duly joined together.
–
Check the correct connection of electric parts.
–
Perform a correct chimney fastening.
–
Check generator correct operation.
FAILING TO CARRY OUT MAINTENANCE
–
Carry out a periodical preventive maintenance and any component repair or replacement operations according to the indica-
tions set forth in the Technical Manual and, anyway, for the cases not provided for in the manual, consult the manufacturer of
the generator.
SYSTEM DOWNTIME
–
The appliance must be stored according to the indications given in the Technical Manual (Wet storage and Dry storage).
–
The generator must be protected against adverse climatic conditions (minimum temperature -10 °C) and rain effects.
ACCESSORY REPLACEMENT
–
The replaced accessories must have the same characteristics of the original ones. To carry out calibration, refer to the technical
manual and, in any case, it is recommended to contact the manufacturer.
PRESSURISED BODY REPAIR
–
To carry out repair operations, contact the manufacturer and/or the body responsible for the check of operating steam gener-
ator (technical and bureaucratic details), and use suitable means and materials.
Cooke Industries - Phone: +64 9 579 2185 Email: sales@cookeindustries.co.nz Web: www.cookeindustries.co.nz
