IR-PAD SERIES USER MANUAL
10
THE ENCAPSULATION RATING IS ONLY APPLICABLE WHEN ALL THE
OPENINGS ON THE CAMERA ARE SEALED WITH THEIR CORRECT COVERS,
HATCHES, OR CAPS. THIS INCLUDES THE COMPARTMENTS FOR DATA
STORAGE, BATTERIES, AND CONNECTORS.
•
Do not get water or salt water on the device or permit its internal
components to get wet. Damage to the device an its battery may occur.
•
Remove any water or moisture on the device before operation. Damage to
the device may occur.
•
If there is a leak from the battery and the fluid gets into the eyes, do not
rub the eyes. Flush well with water and immediately get medical care.
•
Always dispose of the device and its internal components in accordance
with local, state and federal regulations.
•
Do not use the device if, when used, charged, or placed in storage, there
is an unusual smell from the device, the device feels hot, changes color,
changes shape, or is in an unusual condition. Speak with a sales office if
one or more of these problems occurs.
•
Clean the case with a damp cloth and a weak soap solution. Do not use
abrasives, isopropyl alcohol, or solvents to clean the case or lens/screen.
•
Be careful when cleaning the infrared lens. Do not clean the infrared lens
too vigorously. This can damage the anti-reflective coating.
•
Avoid condensation. Taking the imager from cold to hot will cause
condensation in thermal imager. To protect the imager, power on the
device and wait until it becomes warm enough for the condensation to
evaporate.
•
Keep device out of reach of children.
•
It is recommended to calibrate your device annually.
•
Storage: If you do not use the imager for a long period of time, put the
device in a cool and dry environment. The built-in lithium battery will
discharge over time and should be fully charged before storage. It is
recommended to fully recharge the batteries every 3 months to prevent
damage. Store the device in an ambient temperature of -40 °C to 70 °C
(-40 °F to 158 °F).
