54
can access the Internet service through the wireless
network.
Note: In this mode, if you are informed by your
wireless ISP that the wireless settings of the
access point is changed, please configure the
router in this page for match the settings.
staEnable: enable this function and the router can only
allow to be connected through wired Ethernet cable
for WAN access service.
SSID (2):
This is the name of wireless network. Input the SSID
name that your wirelesses ISP provide to you.
Channel Number (3): This is the radio frequency used to transmit and
receive the wireless signal. The wireless devices in
the same network should follow the same setting.
Select the channel designated by your wireless ISP.
Site Survey (4):
Click ‘Select Site Survey’ button, then a “Wireless Site
Survey Table” will pop up. It will list all available
access points nearby. Select the access point
designated by your wireless ISP in the table and the
router will join wireless network through this access
point.
Security Settings (5): If the access point enables wireless security, you have
to follow the same settings in order to access the
access point. Click to set security settings for this
connection (Please go to section ‘2-7-3 Wireless
Security’ for detailed instructions).
After you finish with all settings, please click ‘Apply’ (6) button and the
following message will be displayed on your web browser:
