Remote or Outdoor Sensor Installation (Optional)
1 . Remove cover from remote sensor housing .
2 . Select an appropriate location for mounting the remote sensor .
3 . Mount remote sensor unit using hardware provided .
4 . Install two strand shielded wire between remote sensor and thermostat . Shielded wire must be used .
Do not
run remote sensor wire in conduit with other wires .
•
Wire 1
should run between the S1 terminal on the thermostat and the S1 terminal on the remote sensor
•
Wire 2
should run between the S2 terminal on the thermostat and the S2 terminal on the remote sensor
• Connect the shielding of the wire to the S2 terminal on the thermostat
5 . Configure the thermostat to operate with the remote sensor (see Configuration Mode setting 10, Page 14) .
Note:
Remote or outdoor sensor reading can be displayed by
simultaneously pressing the
Down
and
SYS
buttons .
Remote Sensor: (Shown: Optional ICM ACC-RT103 Remote Indoor Sensor;
for outdoor sensor, order ACC-OD103.)
Summary of Contents for SC 5011
Page 7: ... Hardwired 3 Wire Single Transformer Hardwired 4 Wire Single Transformer Wiring Diagrams ...
Page 9: ... Hardwired Cool or Heat Active Reversing Valve ...
Page 10: ... Hardwired 4 Wire Single Transformer ...
Page 30: ...This page left blank intentionally ...
