51
New2001
TROUBLESHOOTING
8
If your transceiver seems to be malfunctioning, please check the following points before sending it to a service center.
PROBLEM
POSSIBLE CAUSE
SOLUTION
REF.
Transceiver does not turn
ON.
• The battery is exhausted.
• The battery polarity is reversed.
•
Loose connection of a battery pack (case).
• Charge the battery pack, or replace the batteries.
• Check the battery polarity.
• Clean battery terminals.
pp. 1, 13–16
p. 15
–
No sound comes from the
speaker.
• Volume level is too low.
• An external speaker or a cloning cable is con
-
nected to the [SP] jack.
• Rotate [VOL] to adjust to a desired level.
• Check the external speaker connection or remove
the cloning cable.
p. 19
–
Transmitting is impossible.
• A frequency outside of the 430 MHz amateur
bands is set.
• The PTT Lock function is activated.
• Set the frequency within 430 MHz amateur bands.
• Set the PTT Lock function to OFF in the FUNCTION
Menu.
p. 23
p. 44
Transmitting using the VOX
function is impossible.
• The VOX Level is set to
OFF or too low.
• The MIC Gain is
too low.
•
Set the VOX Level to a suitable level.
•
Set the MIC Gain to a suitable level.
p. 59
p. 45
Contacting with another
station is impossible.
• A different tone or code is used for the tone/
DTCS squelch.
• Check the tone/DTCS by performing a tone scan.
p. 27
Frequency cannot be set.
• The Key Lock function is activated.
• The memory mode, Call channel mode, or DR
mode is selected.
• Hold down [LOCK]
for 1 second to cancel the
Key Lock function.
• Push [V/MHz]
to select the VFO mode.
p. 26
p. 21
A program scan does not
start.
• The memory mode, Call channel mode, or DR
mode is selected.
• The same frequency has been programmed in
the scan edge channels, “
✱
A” and “
✱
B.”
• Push [V/MHz]
to select the VFO mode.
• Program different frequencies in the scan edge
channels.
p. 21
p. 28
A memory scan does not
start.
•
The VFO mode or Call channel mode is selected.
• Only one or no memory channel has been pro
-
grammed.
•
Push [M/CALL]
to select the memory mode.
• Program two or more memory channels.
p. 21
p. 28
The displayed frequency is
erroneous.
• The CPU has malfunctioned.
• External factors have caused a fault.
• Reset the transceiver.
• Remove and reattach the battery pack/case.
p. 50
p. 1
Summary of Contents for D-STAR ID-31A; D-STAR ID-31E
Page 76: ...67 MEMO ...
Page 77: ...68 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 MEMO ...
Page 78: ...69 MEMO ...
