36
5
MEMORY OPERATION
New2001
5
■
Memory bank setting
q
Push the desired band’s [M/CALL•MW] several times to
select memory mode, then select the desired memory
channel via the same band’s [DIAL].
w
Push the same band’s [MAIN•BAND] for 1 sec.
• “– –” indication blinks as follows.
e
Push the [MAIN•BAND] again to set the channel to bank
setting stand-by condition.
• “– –” indication blinking stops.
r
Push the [M/CALL•MW] for 1 sec. then rotate the [DIAL] to
select the desired bank to be set.
• Bank initial blinks as follows.
t
Push the [M/CALL•MW] again to set the channel into the
bank.
• “
!
” and bank initial blinking stops.
y
Push the [MAIN•BAND] for 1 sec. then push the
[MAIN•BAND] momentarily again to return to regular mem-
ory condition.
u
Repeat steps
q
to
y
to set another memory channel into
the same or another bank.
z
Push [MR/CALL] then select the desired mem-
ory channel via [
Y
]/[
Z
] or keypad.
• Push [BAND] to select the desired band (left or
right) as the main band, in advance.
x
Push [FUNC] then [
MONI
1(BANK)].
• “– –” indication blinks.
c
Push [
CLR
A(MW)] to set the channel to bank
setting stand-by condition.
• “– –” indication stops blinking.
v
Push [FUNC] then [
CLR
A(MW)] then push
[
Y
]/[
Z
] to select the desired bank to be set.
• Bank initial blinks.
b
Push [
CLR
A(MW)] to set the channel into the
bank.
• “
!
” and bank initial stops blinking.
n
Push [FUNC], [
MONI
1(BANK)] then [
CLR
A(MW)]
to return to regular memory channel condition.
m
Repeat steps
z
to
n
to set an another memory
channel into the same or another bank.
BANK
[
Y
]/[
Z
]
MW
MAIN
T X
M
MAIN
T X
M
IC-2720H_2.qxd 03.5.13 9:45 Page 36 (1,1)
