41
7
SCAN OPERATION
New2001
■
Scan start/stop
D
Preparation
Scan resume condition (p. 45); program the scan edges
(pgs. 42, 43); program 2 or more memory channels (pgs. 30,
31); set skip settings, if desired (p. 44).
D
Operation
q
Select VFO mode for full/programmed scan with
[V/MHz•SCAN]; or memory mode for memory scan with
[M/CALL•MW] in the desired band.
• Select the desired bank with the same band’s [MAIN•BAND] for
bank scan.
w
Set the squelch to the point where noise is just muted.
e
Push the [V/MHz•SCAN] for 1 sec. to start the scan.
• To change the scanning direction, rotate the same band’s [DIAL].
• The memory channel readout blinks the scan type as follows:
r
Push [SET•
] to switch full and programmed scan (P1,
P2, P3, P4 and P5), if VFO is selected in step
q
.
t
To stop the scan, push the [V/MHz•SCAN].
z
Push [VFO/LOCK] to select VFO mode for
full/programmed scan; push [MR/CALL] to select
memory mode for memory scan, in the main
band.
• Push [FUNC] then [
MONI
1(BANK)] to select a bank
for bank scan.
x
Push [
SQL
Y
D(MUTE)] or [
SQL
Z
#(16KEY-L)] to
set the squelch to the point where noise is just
muted.
c
Push [
SCAN
2(T-SCAN)] to start the scan.
• Push [
Y
] or [
Z
] for 1 sec. also starts the scan.
v
Push [
SET
B(D-OFF)] to switch full and pro-
grammed scan (P1, P2, P3, P4 and P5), if VFO
is selected in step
z
.
b
To stop the scan push [
SCAN
2(T-SCAN)] or
[
CLR
A(MW)].
SCAN
2
SET
B
MAIN
T X
M
MAIN
T X
M
MAIN
T X
M
MAIN
T X
M
• During full scan
• During programmed scan
• During memory scan
• During bank scan
Indicates scan edge channels.
• P1 stands for 1A/1b
• P1 to P5 are available when they
are programmed, and switches
with [SET• ].
Indicates bank initial.
Push [SET• ] to select “AL”
(full) or programmed scan (P1,
P2, P3, P4 and P5) in
sequence.
IC-2720H_2.qxd 03.5.13 9:45 Page 41 (1,1)
