3
SET MODE
3-5
D
Mic Gain “MIC”
You can adjust the microphone sensitivity to between
1 (minimum sensitivity) and 5 (maximum sensitivity).
With a higher sensitivity, the microphone picks up
softer voices, though it may pick up more ambient
noise.
D
Lone Worker “LONE”
(
May not be displayed, depending on the
transceiver’s setting.)
Turn the Lone Worker function ON or OFF.
If no operation occurs during the set period, the Lone
Worker function automatically puts the transceiver into
the Emergency mode.
D
AF Minimum Level “AFMIN”
(
May not be displayed, depending on the
transceiver’s setting.)
Set the minimum audio output level to Between 0 and
255. This function determines the minimum audio
output level to let the audio level become lower than
the set level.
Set mode items (Continued)
Mic Gain
sensitivity 3 (default)
Mic Gain sensitivity 1
Lone Worker OFF (default)
Lone Worker ON
AF Minimum
Level 0 (default)
AF Minimum Level 255
D
Own ID
(You can only set this item after enabling the function
using the optional CS-410PRO
cloning
software
.)
This function enables you to allocate your Own ID
which identifies you as a target for Selcall operation
and allows tracking of the origin of transmissions.
1) Enter the editing mode when your Own ID is
displayed.
➥
Hold down [MONI] for 2 seconds.
2) Select the desired number for the blinking digit.
➥
Push [UP]/[DOWN].
3) Set the blinking digit and go to the next digit.
➥
Push [MONI].
4) Repeat steps 2) and 3) until all 5 digits are set, and
then push [MONI] again to save your Own ID.
