15-18
15. ABOUT THE DV GATEWAY FUNCTION
Access Point mode operation
D
Making a Gateway call through the Access Point transceiver
When using the DR function
Step 1. Register the Access Point information to
the Repeater List (Continued)
6. Set “USE (FROM)” to “YES.”
7. Set “FREQUENCY” to the Access Point
transceiver’s operating frequency.
(Example: 430.850)
8. Set “DUP” to “DUP–.”
9. Set “OFFSET FREQ” to “0.000.00.”
10. Select “<<Add Write>>” and write the Access
Point information.
Step 2� Set the Access Point using the DR
function
Set the Access Point registered in Procedure 1
(1. Register the Access Point information to the
Repeater List) to “FROM.”
Step 3� Set “TO” and transmit
1. Set “TO” to a destination.
(Example: Hamacho 430)
L
You can select the “Local CQ,” but cannot make
a call.
2. Hold down [PTT] to transmit.
3. Release [PTT] to receive.
L
If you do not receive a reply, see page 15-24 for
tips on how to solve the problem.
