7-1
7� MEMORY OPERATION
Memory channels
The Memory mode enables you to quickly select
often-used frequencies, modes, and other
parameters. While operating in the Memory
mode, you can temporarily change the operating
frequency, mode, and so on, without overwriting
the memory channel contents.
L
To save the changed value, overwritte the memory
channel contents, or copy to another Memory
channel (p. 7-3).
Group
Memory
channel
Displayed
00 to 99
00 to 99
Regular memory channels with
split frequency capability.
1 frequency, 1 mode, 1 filter,
memory name, tone settings
(including tone frequencies for
repeater and tone squelch), and
select memory scan setting in
each memory channel.
L
Up to 500 channels can be
separately stored in the 100
memory channel groups.
CALL CH 144 C1/C2
430 C1/C2
Call channels with split frequency
capability each of the 144 and
430 bands.
L
They cannot be left blank.
Selecting a memory group
1. Touch the VFO/MEMORY icon.
2. Touch [GROUP].
3. Touch a memory group (00 ~ 99, or CALL CH).
Indicates the listed group.
L
You can toggle the listed group by touching the
icon in the upper left corner of the screen.
• “ALL GROUPS” is displayed when all groups are
listed.
• “ACTIVATE GROUPS” is displayed when only the
groups that have one or more channels are listed.
Entering Memory channel contents
NOTE:
New content you enter will overwrite any
content already in the selected memory.
1. Select the VFO mode. (Basic Manual)
2. Set the frequency, operating mode, and other
parameters.
3. Touch the VFO/MEMORY icon.
4. Touch [MW].
5. Touch “Write to a New Channel.”
6. Touch the desired Memory channel.
(Example: 00)
L
To change a memory group, touch [GROUP].
Touch to change
a memory group.
7. Touch [YES].
• The contents are entered in the selected
Memory channel.
TIP:
Touching [MW] for 1 second in step 4
enters the contents to a blank channel in the
selected group.
