4
RECEIVING AND TRANSMITTING
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
4-7
Notch Filter (Continued)
D
Manual
Notch function
The Manual Notch attenuates beat tones, tuning
signalsandsoonbyadjustingtheNotchfilter’scenter
frequency.
1. Touch [NOTCH] for 1 second.
• The Multi-function menu is displayed, and the Notch
position setting is automatically selected.
NOTE
: While adjusting, noise may be heard.
This comes from the DSP unit but it does not indicate
an equipment malfunction.
2. Rotate
MULTI
to manually attenuate the
frequency.
L
Touching [NOTCH WIDTH]
changestheManualNotchfilter
width between “WIDE,” “MID,”
and “NAR.”
Monitor function
The Monitor function enables you to monitor your
transmit audio. Use this function to check the voice
characteristics while adjusting the transmit audio
parameters.
L
You can hear the CW sidetone regardless of the Monitor
function setting.
1. Select the operating mode that you want to
monitor. (Example: AM)
2. Push
MENU
.
•Opens the MENU screen.
3. Touch [MONI] to turn ON the Monitor function.
L
Touching [MONI] turns the Monitor function ON or OFF.
4. Touch [MONI] for 1 second.
• The Multi-function menu is displayed, and the
MONITOR setting is automatically selected.
5. Rotate
MULTI
to adjust MONITOR to the clearest
audio output between 0% and 100%, while
speaking at your normal voice level.
NOTE
: When using the VOICE DELAY set in the VOX
menu, turn OFF the Monitor function. Otherwise the
transmitted audio will echo.