9-4
■
Programmed scan operation
q
Push
EXIT/SET
several times to close a multi-func-
tion screen, if necessary.
w
Select VFO mode.
e
Select the desired operating mode.
• The operating mode can also be changed while scan
-
ning.
r
Push [SCAN]
F-5
to select the scan screen.
t
Set [SQL] open or closed.
• See page 9-2 for squelch condition.
y
Push [PROG]
F-1
to start the programmed scan.
• “
PROGRAM SCAN
” and decimal points blink while
scanning.
u
When the scan detects a signal, scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch status.
i
To cancel the scan, push [PROG]
F-1
.
• Rotating the main dial also cancels the scan.
o
Hold down [RECALL]
F-6
for 1 second to recall
the frequency that is set before starting the scan, if
desired.
If the same frequencies are programmed into
the scan edge memory channel P1 and P2, pro-
grammed scan will not start.
■
∂
F scan operation
q
Push
EXIT/SET
several times to close a multi-func-
tion screen, if necessary.
w
Select VFO mode or a memory channel.
e
Select the desired operating mode.
• The operating mode can also be changed while scan
-
ning.
r
Push [SCAN]
F-5
to select the scan screen.
t
Set the main band’s [SQL] open or closed.
• See page 9-2 for squelch condition.
y
Set the
∂
F span by pushing [
∂
F SPAN]
F-4
.
• ±5 kHz, ±10 kHz, ±20 kHz, ±50 kHz, ±100 kHz, ±500
kHz and ±1000 kHz are selectable.
u
Set center frequency of the
∂
F span.
i
Push [
∂
F]
F-2
to start the
∂
F scan.
• “
:
F SCAN
” and decimal points blink while scanning.
o
When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch status.
!0
To cancel the scan, push [
∂
F]
F-2
.
• Rotating the main dial also cancels the scan.
!1
Hold down [RECALL]
F-6
for 1 second to recall
the frequency that was set before starting the scan.
[SQL]
Main dial
EXIT/SET
F-1
PROG
[SQL]
Main dial
F-2
∂
F
F-4
∂
F SCAN
EXIT/SET
9
SCANS
