9-6
■
Memory scan operation
q
Push
EXIT/SET
several times to close a multi-func-
tion screen, if necessary.
w
Select memory mode.
e
Push [SCAN]
F-5
to select the scan screen.
r
Set [SQL] open or closed.
• See page 9-2 for squelch condition.
t
Push [MEMO]
F-1
to start the memory scan.
• “
MEMORY SCAN
” and decimal points blink while scan-
ning.
y
When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
u
To cancel the scan, push [MEMO]
F-1
.
• Rotating the main dial also cancels the scan.
2 or more memory channels must be programmed
for memory scan to start.
■
Select memory scan operation
q
Push
EXIT/SET
several times to close a multi-func-
tion screen, if necessary.
w
Select memory mode.
e
Push [SCAN]
F-5
to select the scan screen.
r
Set [SQL] open or closed.
• See page 9-2 for squelch condition.
t
Push [SEL No.]
F-5
several times to select the
select scan number from
★
1,
★
2,
★
3 and
★
1,2,3.
y
Push [MEMO]
F-1
to start the memory scan.
• “
MEMORY SCAN
” and decimal points blink while scan-
ning.
u
Push [SELECT]
F-3
to start select memory scan;
push [SELECT]
F-3
again to return to memory
scan, if desired.
• “
SELECT MEMORY SCAN
” b l i n k s i n s t e a d o f
“
MEMORY SCAN
” during select memory scan.
i
When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
o
To cancel the scan, push [MEMO]
F-1
.
• Rotating the main dial also cancels the scan.
2 or more memory channels must be designated
as select memory channels, as well as the same
select scan channel number, for select memory
scan to start.
[SQL]
Main dial
EXIT/SET
F-1
MEMO
F-3
SELECT
F-5
SEL No.
[SQL]
Main dial
EXIT/SET
F-1
MEMO
9
SCANS
