14
7
CLONING
D
Data cloning
Cloning allows you to quickly and easily
transfer the programmed contents from one transceiver to
another transceiver, or, data from PC to a transceiver using
the optional CS-A110 cloning software.
D
Transceiver to transceiver cloning
q
Connect the OPC-591
CLONING CABLE
with adapter plugs to
the [MIC] jack of the master and slave transceivers.
• The master transceiver is used to send data to the slave trans-
ceiver.
w
While pushing and holding [
Y
] + [
Z
] + [V/M], push
[POWER] ON to enter cloning mode (master transceiver
only—power ON only for slave transceiver).
• “CLONE” appears and the
transceivers enter the clone
standby condition.
e
Push [POWER] on the mas-
ter transceiver.
• “CL-OUT” appears in the
master transceiver’s display.
• “CL-IN” appears automati-
cally in the slave trans-
ceiver’s display.
e
When cloning is finished, turn
power OFF, then ON again to
exit cloning mode.
D
Cloning using PC
Data can be cloned to and from a PC (IBM compatible) using
the optional CS-A110
CLONING SOFTWARE
and the optional OPC-
478
CLONING CABLE
+ OPC-592
CLONING CABLE ADAPTER
. Consult the
CS-A110
CLONING SOFTWARE
HELP message for details.
D
Cloning error
When the display at right ap-
pears, a cloning error has oc-
curred.
In this case, both transceivers automatically return to the
clone standby condition and cloning must be repeated.
]