14
4
MEMORY OPERATION
Memory names
■
Programming memory names
ï
The memory channel can display a 6-character name in-
stead of the programmed frequency.
q
In the frequency mode, rotate [DIAL] to select the desired
frequency in the frequency mode.
w
Push
, then push [MR•
MW
] to program the contents
into the selected memory channel.
e
Rotate [DIAL] to select the desired memory channel to be
programmed.
• Push
, then push [0•
BANK
], and rotate [DIAL] to select the
BANK number, if desired. Push [CLR•
DEL
] to exit the BANK se-
lection mode.
r
Push [MR•
MW
] to enter the memory name programming
mode.
• “-- -- -- -- -- -- ” appears on the display.
t
Push the appropriate digit key several times to select the
desired character, as listed to the right.
• To erase a character, overwrite with a space (displayed as _).
• To move the cursor forwards or backwards, use [DIAL].
y
Push [ENT•
WX
] to program the name.
• The memory name stops flashing.
• When no name is programmed, the display shows the operat-
ing frequency.
• To clear the entered memory names, push [CLR•
DEL
] before
pushing [ENT•
WX
].
NOTE: When programming the memory name to the pro-
grammed memory channel do the following.
q
Follow the same steps as in “Transferring memory con-
tents” (see p. 12).
w
Follow steps
w
–
y
in “Programming memory names”
(see left column).
Clearing the memory contents
■
Unwanted memory channels can be cleared.
q
Select the memory channel to be cleared.
w
Push
, then hold down [CLR•
DEL
] for 1 second.
• “-- -- -- -- -- --” appears momentarily, then the next selectable
channel appears.
Key Character Key Character Key
Character
1
1, Q, Z
2
2, A, B, C
3
3, D, E, F
4
4, G, H, I
5
5, J, K, L
6
6, M, N, O
7
7, P, R, S
8
8, T, U, V
9
9, W, X, Y
ENT
Program
0
0, space, -
