14
3
BASIC OPERATION
D
TX code number edit
(PMR or BIIS PMR operation only)
If the transceiver has [TX Code CH Select] or [TX Code
Enter] assigned to it, TX code contents can be edited within
the allowable digits.
TO EDIT A TX CODE VIA [TX CODE CH SELECT] KEY:
q
Push [TX Code CH Select] to enter the TX code channel
selection mode.
• Select the desired channel using [UP] or [DOWN] if necessary.
w
Push [TX Code CH Select] for 1 sec. to enter the TX code
edit mode.
e
Push [TX Code CH Select] to select the desired digit to be
edited.
r
Set the desired digit using [UP], [DOWN], [TX Code CH
Up], [TX Code CH Down] or 10-keypad.*
*Depending on version.
t
Push [TX Code CH Select] to set the digit. The editable
digit will move to the right automatically.
• When the 10-keypad is used to set, the editable digit will move to
the right automatically without pushing [TX Code CH Select].
y
Repeat
r
and
t
to input all allowable digits.
u
Push [Call] or [PTT] to transmit the edited TX code.
TO EDIT A TX CODE VIA [TX CODE ENTER] KEY:
q
Select the desired TX code channel via [TX Code CH Up]
or [TX Code CH Down].
w
Push [TX Code Enter] to enter the TX code edit mode.
e
Push [TX Code Enter] to select the desired digit to be edit-
ed.
r
Set the desired digit using [UP], [DOWN], [TX Code CH
Up] or [TX Code CH Down] or 10-keypad*.
*Depending on version.
t
Push [TX Code Enter] to set the digit. The editable digit will
move to the right automatically.
• When the 10-keypad is used to set, the editable digit will move to
the right automatically without pushing [TX Code CH Select].
y
Repeat
r
and
t
to input all allowable digits.
u
Push [Call] or [PTT] to transmit the edited TX code.
IC-F34_44GT_GS-1.qxd 04.9.24 10:26 AM Page 14 (1,1)
