4 - 1
SECTION 4
OPTIONAL PRODUCTS INSTALLATION
Install optional UT-108 as follows;
1) Turn the transceiver OFF, then disconnect the DC cable.
2) Unscrew 4 screws, then remove the bottom cover.
3) Install the unit as shown below.
4) Recover the bottom cover, screws and DC power cable.
Install optional OPC-1939 as follows;
1) Turn the transceiver OFF, then disconnect the DC power
cable.
2) Unscrew 4 screws, then remove the bottom cover.
3) Install the cable as shown below.
Install optional UT-109R or UT-110R as follows;
1) Turn the transceiver OFF, then disconnect the DC power
cable.
2) Unscrew 4 screws, then remove the bottom cover.
3) Cut the pattern on the PCB at "MIC" and "DISC" as
showon below.
4) Install the unit as shown below.
5) Recover the bottom cover, screws and DC power cable.
OPC-1939
Cut off the bushing as in the illustration,
when you install the optional OPC-1939.
K
I
MIC
DISC
4) Cut or short the patterns as below. (For AF output)
6) Recover the bottom cover, screws and DC power cable.
NOTE:
Be sure to recover the patterns
when you remove the optional product. Otherwise no TX modulation or AF output is available.
Solder
remover
D
5) Short the pattern as below. (For modulation input)
