16
3
BASIC OPERATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
r
Push [CH Up] or [CH Down] to set the selected item.
12HR 03:00PM
YMD 08-04-01
MON CLCK ZONE
t
Push [Clock] to set.
• The next item blinks.
12HR 03:00PM
YMD 08-04-01
MON CLCK ZONE
y
Repeat steps
e
to
t
to set items.
u
After setting, push and hold [Clock] for 1 sec. to program.
• Return to the time and date setting mode.
i
Push [Clock] to return to the stand-by mode.
■
LED indicator
(Non-display type only)
The LED indicator indicates some information as follows;
(Ref.; R=Red, G=Green, O=Orange)
• TX: Lights Red while transmitting a signal.
TX Low BATT1
O O
G G
G G
G G
G G G G G G G G
R G R G R G R G R G R G R G R G
R O R O R O R O R O R O R O R O
G
G
G
Clone Err
Clone TX/RX
Low BATT2
Low BATT1
Inh & Blank CH
Busy
F/S Scan
Call LED Blink
Call LED ON
TX Low BATT2
TX
R*
R*
R*
R*
R*
R*
R*
O
* Lights (or blinks) orange when the optional battery case is at-
tached.
• TX low BATT1: TX is performed at Low BATT1.
• TX low BATT2: Low BATT2 was detected during TX mode.
• Fast/Slow scan: Blinks while Fast/Slow scan is activated.
• RX: Turns Green while receiving a signal.
• Low BATT1: You should charge the battery. (blinks slowly)
• Low BATT2: You must charge the battery. (blinks fast)
• CH err: Non-programmed channel is selected.
