23
6
SCAN OPERATION
■
Scan resume setting
When a signal is received during a scan, the scan resume
setting determines what action the transceiver takes. The
transceiver has two scan resume settings, as described
below. Use the Set mode to select the one which best suits
your needs.
q
Push
[FUNC](
M
), and then [SET](8) to enter the Set mode.
w
Push
[
] or [
] to select the scan pause timer item (SCt,
or SCP).
e
Rotate
[VOL] to select a scan pause option.
• Pause scan
The scan pauses until the received signal disappears,
and then resumes after 2 seconds.
• Timer scan
The scan pauses for 5 seconds, 10 seconds or 15 sec-
onds, and then resumes.
r
Push
[# ENT](MN.W) to exit the Set mode.
■
Priority watch
The priority watch checks for signals on the selected chan-
nel (Priority channel) every 5 seconds.
The priority channel is pre-programmed by your dealer, and
you cannot change the setting with the transceiver. Ask your
dealer for details.
q
Push
[FUNC](
M
), and then [PRIO](7) to start the watch.
• The decimal point “
.
” on the alphanumeric display
blinks.
• When a signal is detected on the channel, the watch pauses,
and then resumes according to the scan resume setting. (p. 32)
w
To cancel the watch, push any key except
[
], [
]/[
],
[FUNC], [
] or [MONI].
NOTE: When you start the priority watch, the Tone func-
tion and the output power are automatically returned to
the setting or level pre-programmed by your dealer.
[VOL]
Pause scan
Timer scan (15 seconds)
Operating channel
Priority channel
5 seconds
