Icom IC-iF9511HT, Instruction Manual

5

1

PANEL DESCRIPTION

PRIO A/B KEYS

➥

  Push to select Priority A or Priority B channel.

➥

  Push and hold [Prio A (Rewrite)] or [Prio B (Rewrite)] for 

1 sec. to rewrite the operating channel as the Priority A or 
Priority B channel.

MR-CH 1/2/3/4 KEYS

Push to select the memory channel 1 to 4 directly.

MONI KEY

Mute and release the CTCSS (DTCS), NAC or Talkgroup ID 
squelch mute. Open any squelch/deactivate any mute while 
pushing this key.

TALK AROUND KEY

 (Conventional operation only)

Turn the talk around function ON and OFF.

•  The talk around function equalizes the transmit frequency to the 

receive frequency for transceiver-to-transceiver communication.

PUBLIC ADDRESS KEY

Push to activate the Public Address (PA) function for voice 
amplification. When the PA function is activated, the audio 
output can be controlled from the transceiver separately with 
[CH Up] or [CH Down].

•  This function is available when the external unit, such as a audio 

amplifier, speaker, etc. is additionally connected. (p. 16)

•  Push this key, then speak into the microphone while pushing and 

holding [PTT].

NOTE:

 “PA/RX Speaker” setting should be turned OFF by 

your dealer with the CS-F9010/F9510 

cloning

software

to activate the PA function. Ask your dealer for details.

RX SPEAKER KEY

Push to turn the RX speaker function ON or OFF.
When the RX speaker function is turned ON, the received 
audio can be heard via the external speaker.

•  This function is available when the external speaker is additionally 

connected. (p. 16)

•  This function is useful when you are out of the vehicle.
•  The audio output level is linked to the transceiver’s volume control.

DO NOT

 operate this key with this transceiver. Otherwise 

no audio may be emitted. 

LOCK KEY

Push and hold to electronically lock all programmable keys 
except the following:

[Moni], [Light], [Lock], [Emergency Single], [Emergency Repeat], 
[Surveillance] and [OPT 1/2/3].

LIGHT KEY

Push to turn the transceiver’s backlight ON for about 5 sec. 
when the backlight function is turned OFF in user set mode. 
(p. 12)

HIGH/LOW KEY

Push to select the transmit output power temporarily or per-
manently, depending on the pre-setting.

• Ask your dealer for the output power level for each selection.