TROUBLESHOOTING
8
18
PROBLEM
POSSIBLE CAUSE
SOLUTION
REF.
No power comes ON.
• The battery is exhausted.
• Bad connection to the battery pack.
• Recharge the battery pack.
• Check the connection to the transceiver.
p. 15
p. 2
No sound comes from
the speaker.
• Squelch level is too deep.
• Volume level is too low.
• Speaker has been exposed to water.
• Set squelch to the threshold point.
• Set [OFF/VOL] to a suitable level.
• Drain water from the speaker.
p. 6
p. 7
—
Transmitting is impossi-
ble, or high power can-
not be selected.
• Some channels are for low power or re-
ceive only.
• The battery is exhausted.
• The output power is set to low or extra low.
• Change channels.
• Recharge the battery pack.
• Push [H/L] to select high power.
pgs.
5, 7
p. 15
p. 7
The displayed channel
cannot be changed.
• Lock function is activated.
• Push [
H/L•
LOCK] for 1 sec. to cancel the
function.
p. 6
Scan does not start.
• “TAG” channel is not programmed.
• Set the desired channels as “TAG” chan-
nels.
p. 12
Scan starts automati-
cally.
• Auto scan function is activated.
• Cancel the auto scan function in SET
mode.
p. 14
No beep sounds.
• Beep tone is turned OFF.
• Turn the beep tone ON in SET mode.
p. 13
Receive signal cannot
be understood.
• Optional voice scrambler is turned OFF.
• Scramble code is not set correctly.
• Turn the optional voice scrambler ON.
• Reset the scramble code.
p. 8
p. 8
