2
Select the channel you wish to
program by turning the large
right-hand knob (channel selector
knob)
The channel selector knob
selects channels within a
Channel Group
.
3
Press the
CLAR/RX
button
The small right pointing will
appear next to the RX on
the top line of the LCD
display. The channel label
will be replaced with the
stored frequency and
mode, and a cursor
(underline) will be under
one of the numbers
4
Enter the desired frequency using
the
keypad
, or dial it in using the
two large front panel knobs.
You are entering a new
receive & transmit
frequency.
5
Press and hold the
ENT
key. When
the small right pointing arrow
disappears, the LCD display
reverts back to showing the
channel label, and SIMP is
displayed on the top line, the new
frequency and mode has been set.
Stores the new RX & TX
frequency and mode for
this radio channel into the
M-802's permanent
memory.
Programming Duplex Frequencies into the User Channel Group
Step
Instructions
What's Happening
1
Store the receive frequency
following the instructions for
programming a simplex frequency
described above.
Writes the receive
frequency into memory.
2
Press the
TX
key
LCD displays changes to
the frequency mode and TX
flashes.
5
Enter the new transmit frequency
using the
keypad
, or
knobs
.
6
Press and hold the
ENT
key.
Writes the new transmit
frequency into memory.
The LCD display reverts
back to showing the
channel label and DUP
replaces SMIP.
Adding Names/Labels to Your Channels
Step
Instructions
What's Happening
1
Press the
Freq/CH
button to put
the M-802 into the
Channel Mode
if necessary.
Put the M-802 into the
Channel Mode.
2
Press the "
F
" (Function button)
Enable the function mode.
3
Press the
Freq/CH
The LCD dial display will
show a line of character
positions.
WWW.RADIOS.NET.AU
ICOM M802 PROGRAMMING INSTRUCTIONS
t. 07-41257700 f 03-8640-0419 e.
