22
9
SET MODE
New2001
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
D
AquaQuake Action
“
”
Selects whether or not to activate the AquaQuake water
draining function by shaking the transceiver.
•OFF: While holding down [H/L], push [FAV] to turn ON
the function.
•
ON: You can use the function by just shaking the
transceiver within 30 seconds, after the water is
detected.
D
Man Down Alarm
“
”
Sets the emergency mode detection angle to between 45,
60, or 75 degrees for the Man Down Alarm function.
If the transceiver leans past the set angle for the preset
period of time, an alarm sounds.*
L
Push [PTT] to stop the alarm.
* An alarm sounds from the transceiver’s speaker, even if an
optional speaker microphone is connected.
D
Lone Worker Alarm
“
”
Turns the Lone Worker Alarm ON or OFF.
If no operation occurs for the preset period of time, an alarm
sounds.*
L
Push [PTT] to stop the alarm.
* An alarm sounds from the transceiver’s speaker, even if an
optional speaker microphone is connected.
•OFF: The function is OFF.
•
ON: If no operation occurs during a specified period
of time, the transceiver automatically enter the
Emergency mode.
D
Auto Volume Up
“
”
Turns the Auto Volume Up function ON or OFF.
•OFF: The function is OFF.
•ON: The volume level is automatically increased when
a signal is received in a noisy environment while
the ship is pitching or rolling.
D
MOB Alarm
“
”
Turns the MOB Alarm function ON or OFF.
This function is used when you fallen into the water and
needs to be rescued.
* An alarm sounds from the transceiver’s speaker, even if an
optional speaker microphone is connected.
•OFF: The function is OFF.
•ON: An alarm sounds while the transceiver is in the water.