4-4
4.
SCAN OPERATION
LOCK
SET
ANM
MONI
DUP
LOW
T-SCAN
TONE
PRIO
M/CALL
SCAN
V/ MHz
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
VFO scan
1� Push [V/MHz SCAN] to select the VFO mode�
2� Set the squelch to the point where the noise just
disappears�
3� Hold down [V/MHz SCAN] for 1 second to start
scanning�
• The frequency decimal point and the selected scan
type icon blink�
L
When a signal is detected, the scan pauses
according to the Scan Stop timer setting, and then
resumes�
L
Push [MONI ANM PA] to stop or resume the scan�
4� Push [V/MHz SCAN] to cancel the scan�
TIP:
• During a scan, rotating [DIAL] changes the
scanning direction�
• Push [SET LOCK] to switch between a Full scan
and a Programmed scan (P1, P2, or P3)�
L
P1, P2, or P3 can be selected only when their
Program Scan Edges are entered�
LOCK
SET
ANM
MONI
DUP
LOW
T-SCAN
TONE
PRIO
M/CALL
SCAN
V/ MHz
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK
SET
ANM
MONI
DUP
LOW
T-SCAN
TONE
PRIO
M/CALL
SCAN
V/ MHz
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
Push [V/MHz SCAN] to select the VFO mode�
Hold down [V/MHz SCAN] for 1 second to start
scanning�
“�” and “AL” blink�
Example: Starting a Full scan.
Using the HM-133V
microphone
1� Push [VFO/LOCK] to select the VFO mode�
2� Set the squelch to the point where the noise just
disappears�
3� Push [SCAN 2 T-SCAN] to start scanning�
• The frequency decimal point and the selected scan
type icon blink�
L
When a signal is detected, the scan pauses
according to the Scan Stop timer setting, and then
resumes�
L
Push [MONI 1 ANM] to stop or resume the scan�
4� Push [SCAN 2 T-SCAN] to cancel the scan�
TIP:
•
You can also start scanning by holding down [▲]
or [▼] for 1 second.
• Push [SET B D-OFF] to switch between a Full
scan and a Programmed scan (P1, P2, or P3)�
LOCK
SET
ANM
MONI
DUP
LOW
T-SCAN
TONE
PRIO
M/CALL
SCAN
V/ MHz
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
Push
�
Push
�
Example: Starting a Full scan.
“�” and “AL” blink�