INSTALLATION GUIDE
Thank you for choosing this Icom product. READ ALL
INSTRUCTIONS carefully and completely before using
this product.
opc- 2350lu
The COM port number is used to set communication
with the cloning software.
• To confirm the driver availability and the port num-
ber, log in as the
administrator
.
• Confirm no other applications are running.
q
Right-Click the icon as shown below, and then click
“Device Manager.”
• “Device Manager” is displayed.
w
Click “Ports (COM & LPT).” Confirm “USB Serial
Port (COM
✱
)” is displayed.
• In this example, the COM port number is “3.”
NOTE:
• If the COM port number is not displayed, double-
click “Other devices.”
• If the warning symbol “ ” with “FT232R USB
UART” is displayed, the driver may not be prop-
erly installed. In such case, install the USB driver
manually. Refer to the next page for manual USB
driver installation details.
COM PORT CONFIRMATION
This installation guide describes the COM port confirmation steps, and the manual installation of the OPC-2350LU
USB driver. Refer to the instruction manual for system requirements details.
NOTE:
• After the automatic driver installation has been completed, confirm the driver availability and the port number.
• The displayed dialog boxes, indications or operations may slightly differ from the following instructions, de-
pending on your operating system, system settings and its service pack level.
• These instructions are based on using Microsoft
®
Windows
®
10.
DATA CABLE
q
Click
w
Confirm
w
Click
q
Right-Click
