48
SELECTIVE CALL MODE APPLICATION
2
■
Using with a headset
S����� 9 O����������
• M�k��g � ��ll f��� ��h�� ����������v���.
q
Turn ON the power to Transceiver 2, and then set its operating channel to the
same as Transceiver 1.
w
Hold down transceiver 2’s [PTT], and then push [4]* and [#] to transmit DTMF
signals to connect to the headset through transceiver 1 and the VE-PG2.
* �4�� is the destination number used in this example. The number depends on the �Call
�4�� is the destination number used in this example. The number depends on the �Call
4�� is the destination number used in this example. The number depends on the �Call
�� is the destination number used in this example. The number depends on the �Call
is the destination number used in this example. The number depends on the �Call
�Call
Call
destination number setting,�� in �Numbering plan�� (p. 126).
�� in �Numbering plan�� (p. 126).
in �Numbering plan�� (p. 126).
�Numbering plan�� (p. 126).
Numbering plan�� (p. 126).
�� (p. 126)..
e
A calling notice tone sounds at the external headset. The headset operator must
turn ON the switch to communicate with the transceiver.
r
Hold down transceiver 2’s [PTT], and then speak into the microphone. Release to
receive.
t
Hold down transceiver 2’s [PTT], and then push [#] to transmit DTMF signals to
disconnect the communication route.
• Also, if the VE-PG2 receives no audio for 15 seconds, the communication route is
disconnected.
• M�k��g � ��ll f��� h���������
q
The power to Transceiver 2 must be ON, and its operating channel must be set to
the same as transceiver 1.
w
Turn ON the Switch when you received a call from the headset through the
VE-PG2.
e
Only speak when the transceiver operator stops speaking. Pause briefly before
you begin, to confirm they have finished speaking.
r
Turn OFF the Switch to disconnect the communication route to the transceiver.
• Also, if the VE-PG2 receives no audio for 15 seconds, the communication route is
disconnected.