69
VE-PG2 SETTING SCREEN
3
2
3
4
5
6
7
8
9
10
11
1
w
C����������� ����� �u�b���
Set the destination VE-PG2’s port number.
(Default: Multicast mode:22510, Unicast mode: 21506)
• You can set the port number to between 2 and 65534 (even numbers only).
e
M� ��������� ����� �u�b���
Set the VE-PG2 communication port number.
(Default: Multicast mode:22510, Unicast mode: 21506)
• You can set the port number to between 2 and 65534 (even numbers only).
• DO NOT set the same port number to [TRX1]–[TRX3], [IN] or [OUT].
r
C����������� ������
Set the send/receive signal timing to/from the [IN] and [OUT] ports.
(Default: See EXT Input setting)
• See EXT Input setting : The [IN] and [OUT] ports are connected to the IP network to send
signals.
The connection timing is dependent on the �Valid timing�� setting.
(p. 79)
• Transmit only
: The [IN] and [OUT] ports are always connected to the IP network
to send signals.
• When the VE-PG2 does not detect signals from the [IN] and
[OUT] ports, it does not send any audio signals.
• The [IN] and [OUT] ports sends no audio if the VE-PG2 receives
audio signals from the IP network.
• Receive only
: The [IN] and [OUT] ports send audio signals while the VE-PG2
receive audio signals from IP network.
• The VE-PG2 sends no audio to IP network if the [IN] and [OUT]
ports receive audio signals.
