74
VE-PG2 SETTING SCREEN
3
■
Connection setting (Bridge mode)
3-7 TRX/EXT T��������v��� 1 (TRX1)–T��������v��� 3 (TRX3)
ï
T��������v��� �������l ���������g
Set the transceiver control settings. The transceivers, connected to the [TRX1]–
[TRX3] ports, are controlled according to these settings.
Place the mouse pointer on �Connection setting,�� and then on �TRX/EXT,�� and then
�Connection setting,�� and then on �TRX/EXT,�� and then
Connection setting,�� and then on �TRX/EXT,�� and then
,�� and then on �TRX/EXT,�� and then
�� and then on �TRX/EXT,�� and then
and then
click on one of the Transceiver ports, TRX1, TRX
on one of the Transceiver ports, TRX1, TRX2 or TRX3 shown on the list.
q
T��������v��� ������������ �������������
Set the transceiver detection for each port to �Enable�� or �Disable.��
When �Disable�� is set, some connections may cause the port’s indicator to
mistakenly light. Therefore we recommend you always use the default setting,
�Enable.��
(Default: Enable)
w
P�������� �������v�� �����
Set the Priority receive mode to �Enable�� or �Disable.��
(Default: Disable)
• Disable : The VE-PG2 allows the VOX to switch the transceiver from receive to transmit,
normally.
• Enable : While the transceiver is receiving a signal, the VE-PG2 keeps it in the receive mode,
even if the VOX circuit detects audio.
e
Tx v�lu���
Set the VE-PG2’s transmitting audio level that is sent to the connected transceiver.
(Default: 0)
(Selectable range: –18 to +6 (dB), 1 dB steps)
r
Rx v�lu���
Set the VE-PG2’s audio output level of the AF signal that is received from the
connected transceiver.
(Default: 0)
(Selectable range: –18 to +6 (dB), 1 dB steps)
q
w
e
r
