96
VE-PG2 SETTING SCREEN
3
3-17 TRX/EXT T��������v��� 1 (TRX1)–T��������v��� 3 (TRX3)
ï
T��������v��� �������l ���������g
Set the details of the transceiver control for the [TRX1]–[TRX3] ports.
Place the mouse pointer on �Connection setting,�� and then on �TRX/EXT,�� and then
click on one of the Transceiver ports, TRX1, TRX2 or TRX3 shown on the list.
q
T��������v��� ������������ ������������
Set the transceiver detection for each port to �Enable�� or �Disable.��
When �Disable�� is set, some connections may cause the port’s indicator to
mistakenly light. Therefore we recommend you always use the default setting,
�Enable.��
(Default: Enable)
w
P�������� �������v�� �����
Set the Priority receive mode to �Enable�� or �Disable.��
(Default: Disable)
• Disable : The VE-PG2 allows the VOX to switch the transceiver from receive to transmit,
normally.
• Enable : While the transceiver is receiving a signal, the VE-PG2 keeps it in the receive mode,
even if the VOX circuit detects audio.
e
Tx v�lu���
Set the VE-PG2’s transmitting audio level that is sent to the connected transceiver.
(Default: 0)
(Select range: –18 to +6 (dB), 1 dB steps)
r
Rx v�lu���
Set the VE-PG2’s audio output level of the AF signal that is received from the
connected transceiver.
(Default: 0)
(Select range: –18 to +6 (dB), 1 dB steps)
t
PTT ������l �����
Set cancel a call if the transceiver receives a transmit request while calling.
(Default: Disable)
q
w
■
Connection setting (Selective call mode)
e
r
t