130
VE-PG2 SETTING SCREEN
3
3-27 Ab�����l ���������� ��������
ï
M������� fu������� ���������g
Set the monitor function when a communication error occurs.
Place the mouse pointer on �Connection setting,�� and then click �Abnormal condition
monitor�� shown on the list.
q
LAN ����� ��w�l��k:
Select a monitoring devices.
(Default:
o
LAN port downlink)
w
PING ��������������g ������ ��� �������������� h����:
When the Ethernet cable is disconnected from the VE-PG2’s [LAN] port, the [LAN]
indicator blinks red, and the error message is displayed on �SYSLOG�� in �Informa-
tion.��
• If you check the �EXT Output�� radio button to �Enable,�� the VE-PG2 sends the signal to [OUT]
port when the communication error occurs.
• Set �Use control output�� to �Enable�� the error detect signal outputs to the [A], [B] or [C] ports.
• While the error detect signal is sent, the VE-PG2 can not receive a signal from the external
device that is connected to the [OUT] port.
(Default:
o
PING transmitting error to appointment host)
e
IP ��������:
The VE-PG2 automatically sends PING commands to the specified IP address.
• �
IP address
�� appears when the �
PING transmitting error to appointment host
�� check
box is checked.
• PING command send interval and specified IP address can be set in the same screen.
• When a PING error occurs, the [LAN] indicator blinks alternately red and green, and the error
message is displayed on �
SYSLOG
�� in �
Information
.��
• When �Use control output�� is set to �Enable,�� the error detection signal is sent to the [A], [B] or
[C] ports.
• While the error detection signal is sent, the VE-PG2 can not receive signals from the external
device that is connected to the [OUT] port.
■
Connection setting (Selective call mode)
w
e
q