57
VE-PG2 SETTING SCREEN
3
3-2 IP �����w��k ������������ T��������v��� 1 (TRX1)–T��������v��� 3
(TRX3)
ï
IP �����w��k ������������ ���������g
Set the [TRX1]–[TRX3] port network setting for operation in Bridge mode.
Place the mouse pointer on �Connection setting,�� and then on �IP network
�Connection setting,�� and then on �IP network
Connection setting,�� and then on �IP network
,�� and then on �IP network
�� and then on �IP network
connection,�� and then click on one of the Transceiver ports, TRX1, TRX2 or TRX3
and then click on one of the Transceiver ports, TRX1, TRX2 or TRX3
click on one of the Transceiver ports, TRX1, TRX2 or TRX3
on one of the Transceiver ports, TRX1, TRX2 or TRX3
n one of the Transceiver ports, TRX1, TRX2 or TRX3
2 or TRX3
or TRX3
shown on the list.
• You cannot set these settings when �During transmit�� or �During receive�� is displayed in the
status field of �IP network connection status.��
• The default settings (
q
–
r
) are dependent on �IP communication mode setting.��
q
C����������� IP ��������
Set the destination VE-PG2’s IP address.
(Default: Multicast mode: 239.255.255.1, Unicast mode*: Blank)
[NOTE]
• When you set �IP communication mode setting�� (p. 55) to �Multicast mode,�� set the IP address
to �224.0.0.0��–�239.255.255.255.��
To operate the VE-PG2 in the Multicast mode, set ALL the VE-PG2s’ Connection IP address
to same address.
• When you set �IP communication mode setting�� to �Unicast mode,�� set the destination
VE-PG2’s IP address.
You can also set a domain name (up to 63 characters) instead of the IP address.
q
w
e
r
2
3
4
5
6
7
8
9
10
11
1