61
VE-PG2 SETTING SCREEN
3
2
3
4
5
6
7
8
9
10
11
1
3-3 IP �����w��k ������������ EXT I��u�� (EXT IN)
ï
IP �����w��k ������������ ���������g
Set the signal destination from the external equipment through the [IN] port, in this
screen.
Place the mouse pointer on �Connection setting,�� and then on �IP network
�Connection setting,�� and then on �IP network
Connection setting,�� and then on �IP network
,�� and then on �IP network
�� and then on �IP network
connection,�� and then click �EXT Input (EXT IN)
and then click �EXT Input (EXT IN)
click �EXT Input (EXT IN)
�EXT Input (EXT IN)
EXT Input (EXT IN)�� shown on the list.
• You cannot set these settings when �During transmit�� is displayed in the status field of �IP
network connection status.��
• The default settings (
q
–
r
) are dependent on �IP communication mode setting.��
q
C����������� IP ��������
Set the destination VE-PG2’s IP address.
(Default: Multicast mode: 239.255.255.1, Unicast mode: Blank)
• When you set �IP communication mode setting�� to �Multicast mode,�� set the IP address to
between �224.0.0.0�� and �239.255.255.255.��
To operate the VE-PG2 in the Multicast mode, set ALL the VE-PG2s’ Connection IP address
to same address.
• When you set �IP communication mode setting�� to �Unicast mode,�� set the destination
VE-PG2’s IP address.
You can also set a domain name (up to 63 characters) instead of the IP address.
q
w
e
r
