6
CONVERTER MODE SETTING SCREEN
6-108
9. [Port Settings] Menu (continued)
M
Release Timer
Configure the timer details for call, forced disconnection and so on.
q
Call Cancel Timer ………
Enter the time period to cancel the calling. When the set time has passed
without the response from the IP phone, the transmission is cancelled.
(Default: 15)
Range: "0 (OFF)," "5" to"60" (sec.)
w
No Voice Release Timer …
Enter the time period to stop the transmission. When the set time has passed
with no audio signal, the transmission is stopped.
(Default: 15)
Range: "0 (OFF)," "5" to"600" (sec.)
e
DID Disconnect Timer ……
The waiting time for DID (Direct Inward Dialing) function. When no dial input
is detected for this time period, the communication route will be disconnected.
(Default: 60)
Range: "0 (OFF)" to "120" (sec.)
• The DID (Direct Inward Dialing) function allows you to call the specified
radio from an IP phone.
Forced Disconnect
r
Forced Disconnect Timer
Enter the time period to be forced to stop the transmission. When the set time
has passed, the transmission is stopped even when the communication is
going on.
(Default: 10)
Range: "0 (OFF)," "5" to"120" (minutes)
[Port Settings]–[Bridge 1–Bridge 4]
