4
RouTER SETTINGS
4-13
■
NAT
Set the NAT.
L
This function cannot be used when “LAN port” is selected in “Connection Type.”
■
DMZ Host
Set the DMZ Host function.
L
This function cannot be used when “LAN port” is selected in “Connection Type.”
Router Settings > NAT
Router Settings > NAT
NAT screen
NAT ������������
Select “Enable” to use the NAT function.
(Default: Enable)
The NAT function converts the WAN global address into a private address.
1
DMZ Host IP Address ��
Enter the DMZ Host IP address.
The DMZ Host function (DeMilitarized Zone) transfers an unknown IP
frame from the WAN (Internet) to the specified IP address on the LAN.
But you need to pay attention because it also decreases the security of
the IP address, which is specified as the transfer destination.
L
When the DMZ Host function and Port Forwarding are used at the same
time, Port Forwarding is prioritized.
L
Icom is not responsible for any results caused by a decline in security.
2
<Apply> ��������
Click to apply the entries.
3
<Reset> ��������
Click to reset the settings.
L
You cannot reset after clicking <Apply>.
1
2
3
