13
6.
Carefully slide the Upright Crossbar (76)
between the Right and Left Uprights (84, 91).
Attach the Upright Crossbar with four 5/16" x
3/4" Screws (1);
start all four Screws, and then
tighten them.
6
91
1
76
84
1
7.
Hold the Tray (79) near the Right Upright (84).
Next, locate the tie in the indicated hole (F) in
the Upright. Wrap the tie around the end of the
fan wire (G), and pull the fan wire into the hole
and out of the top of the Upright. Then, remove
the tie (A).
Identify the #8 x 3/4" Truss Head Screws (24).
IMPORTANT: Do not confuse the #8 x 3/4"
Truss Head Screws with the #8 x 3/4" Screws
(5). The #8 x 3/4" Truss Head Screws have
flatter heads.
Attach the Tray (79) to the Upright Crossbar (76)
with four #8 x 3/4" Truss Head Screws (24);
start
all four Truss Head Screws, and then tighten
them.
7
24
84
A
G
76
24
79
F
8. Attach the two Handrails (74) to the Right and
Left Uprights (84, 91) with two of the 5/16" x 2"
Screws (2) that you removed in step 5 and two
5/16" Star Washers (8);
do not fully tighten the
Screws yet. Do not pinch the Upright Coaxial
Cable (78), the Upright Wire (83), or the fan
wire (G). Position the wires as shown.
Then, remove and discard the two indicated
screws (H).
H
78
91
74
8
8
2
G
H
83
74
8
2
84
