13
10. If necessary, move the treadmill to the desired
location. IMPORTANT: Before moving
the treadmill, see HOW TO MOVE THE
TREADMILL on page 24.
After the treadmill is placed in the location where
it will be used, make sure that the Leveling Feet
(64) rest firmly on the floor. If the treadmill rocks
even slightly, loosen the nut on a Leveling Foot,
turn the Leveling Foot clockwise or counterclock-
wise until the rocking motion is eliminated, and
then tighten the nut.
64
10
11. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Note: Extra hardware may be included.
If you purchased the optional MYE receiver to set up a wall of TVs, follow the step below to install the
MYE receiver. To order the MYE receiver, see the back cover of this manual.
12. Remove the four #8 x 1/2" Machine Screws (21),
and then remove the Access Door (99).
Next, unplug the cable labeled "In" (I) and the
cable labeled "Out" (J) from the coupler (K).
Discard the coupler. Next, plug the cable labeled
“In” into the “In” port on the receiver (L), and plug
the cable labeled “Out” into the “Out” port on the
receiver.
Next, peel the backing (M) off the receiver (L),
and press the receiver onto the Access Door
(99) in the location shown by the dashed line.
Then, reattach the Access Door (99) with the
four #8 x 1/2" Machine Screws (21).
21
L
K
99
I
J
12
M
