27
5. Remove the Walking Belt (46) and the Walking
Platform (44) from the treadmill. Next, remove the
Walking Belt from the Walking Platform. Then,
remove the eight 3/8" Nuts (34) and the eight
3/8" x 1 3/4" Bolts (5), and slide the Rear and Front
Platform Brackets (47, 48) off the Walking Platform.
Next, remove the four #16 x 1 1/2" Screws (51) and
the two Platform Cushions (134).
Next, remove the twelve #10 Nuts (65), the twelve
#10 Washers (40), the twelve #10 x 1 1/2" Bolts
(12), and the six Foot Rail Brackets (136). Then,
peel off and save the four Foot Rail Pads (85).
Check to see whether both sides of the Walking
Platform (44) are worn. If the underside has not pre-
viously been used, turn over the Walking Platform
and continue to use it. If the Walking Platform
has previously been turned over, discard the old
Walking Platform. Save all other parts.
Using the new Walking Platform (44) or the old
Walking Platform with the unworn side facing
upward, carefully follow steps 1–5 in reverse order.
If you are also replacing the Walking Belt (46), use
the new Walking Belt. Then, go to step 6.
6. Lift the right or left edge of the Walking Belt (46)
and look for a small arrow printed on the under-
side of the Walking Belt; move the Walking Belt,
if necessary, as you look for an arrow. If you find
an arrow, make sure that the arrow is pointing
toward the rear of the treadmill, as shown. If
it is not, remove the Walking Belt, turn it around,
and slide it back onto the Walking Platform (44).
Note: Your walking belt may not have an arrow. If it
does not have an arrow, it can be turned either way.
Next, move the Walking Belt (46), if necessary, until
the seam (not shown) across the Walking Belt is
beneath the Walking Platform (44).
Then, locate the indicated marks on the left and
right sides of the Walking Belt (46). The inside
edges of both marks should be exactly 36" apart.
12
136
136
136
85
5
34
34
5
5
5
46
51
51
134
134
34
47
48
34
85
46
44
Arrow
Mark
Mark
36"
6
44
65
40
