ICON Health & Fitness NETL14819.0, User Manual

30

MAINTENANCE

Regular maintenance is important for optimal per-

formance and to reduce wear. Inspect and properly 

tighten all parts each time the treadmill is used. 

Replace any worn parts immediately.

Regularly clean the treadmill and keep the walking belt 

clean and dry. First, press the power switch into the 

off position and unplug the power cord. Wipe exte-

rior parts of the treadmill with a damp cloth and a small 

amount of mild soap. IMPORTANT: Do not spray 

liquids directly onto the treadmill. To avoid damage 

to the console, keep liquids away from the console. 

Then, thoroughly dry the treadmill with a soft towel.

TROUBLESHOOTING

Most treadmill problems can be solved by follow-

ing the simple steps below. Find the symptom that 

applies, and follow the steps listed. If further assis-

tance is needed, see the front cover of this manual. 

SYMPTOM: The power does not turn on

a.   Make sure that the power cord is plugged into a 

properly earthed outlet (see page 17). If an exten-

sion cord is needed, use only a 3-conductor, 

14-gauge (2 mm

2

) cord that is no longer than 5 ft. 

(1.5 m).

b.   After the power cord has been plugged in, make 

sure that the key is inserted into the console.

c.   Check the power switch located on the treadmill 

frame near the power cord. If the switch protrudes 

as shown, the switch has tripped. To reset the 

power switch, wait for five minutes and then press 

the switch back in.

SYMPTOM: The power turns off during use

a.   Check the power switch (see drawing c at the left). 

If the switch has tripped, wait for five minutes and 

then press the switch back in.

b.   Make sure that the power cord is plugged in. If the 

power cord is plugged in, unplug it, wait for five 

minutes, and then plug it back in.

c.   Remove the key from the console, and then  

reinsert it.

d.   If the treadmill still will not run, please see the front 

cover of this manual.

SYMPTOM: The incline of the treadmill does not 

change correctly

a.     Calibrate the incline system of the treadmill (see 

step 4 on page 26). When the incline system is 

calibrated, remove the key from the console.

SYMPTOM: The treadmill will not connect to the 

wireless network

a.   Make sure that the wireless settings on the console 

are correct (see page 26).

b.   Make sure that the settings for your wireless net-

work are correct.

c.   If you still have questions, go to support.iFit.com.

Reset

Tripped

c

MAINTENANCE AND TROUBLESHOOTING