17
HOW TO TURN ON THE POWER
IMPORTANT: If the treadmill has been exposed to
cold temperatures, allow it to warm to room tem-
perature before you turn on the power. If you do
not do this, you may damage the console display
or other electrical components.
Plug in the power cord (see
page 15). Next, locate the
power switch on the treadmill
frame near the power cord.
Make sure that the switch is
in the reset position.
IMPORTANT: The console features a display demo
mode, designed to be used if the treadmill is dis-
played in a store. If the demo mode is turned on,
the display will show a demo presentation after
you plug in the power cord and press the power
switch into the reset position, before you insert the
key. To turn off the demo mode, see step 7 on
page 26.
Next, stand on the foot
rails of the treadmill.
Locate the clip at-
tached to the key, and
slide the clip securely
onto the waistband of
your clothes. Then, in-
sert the key into the
console.
IMPORTANT:
In an emergency, the key can be pulled from the
console, causing the walking belt to slow to a stop.
Test the clip by carefully taking a few steps back-
ward; if the key is not pulled from the console, ad-
just the position of the clip.
Note: It may take a minute for the console to be
ready for use.
HOW TO SET UP THE CONSOLE
Before using the treadmill for the first time, set up your
console.
1. Connect to a wireless network.
See steps 1 and 2 on
page 25 to connect to a
wireless network. Then,
touch the back button
on the screen to return
to the settings mode.
An information box may appear to explain how to
return to the settings mode. To hide this message
in the future, touch the Donʼt Show Again check-
box. Then, touch the Continue button.
2. Calibrate the screen.
First, select the maintenance mode (see steps 1
and 2 on page 27). Then, see step 6 on page 28
and calibrate the screen.
3. Calibrate the incline system.
First, select the maintenance mode (see steps 1
and 2 on page 27). Then, see step 3 on page 27
and calibrate the incline system of the treadmill.
4. Check for firmware updates.
See step 5 on page 27 and check for firmware up-
dates.
5. Create an iFit Live account.
Note: If you have already created an iFit Live ac-
count, proceed to step 6.
See step 1 on page 25 to select the settings mode.
Touch the globe button near the lower-left corner
of the screen and then touch the iFit Live button.
A box may appear with directions for navigating in
the Internet browser. To hide this message in the
future, touch the Donʼt Show Again checkbox.
Then, touch the Continue button. Note: For infor-
mation about navigating in the browser, see page
24.
Reset
Key
Clip
