11. If necessary, move the treadmill to the desired
location (see HOW TO MOVE THE TREADMILL
on page 25).
After the treadmill is placed in the location where
it will be used, make sure that the Leveling Feet
(64) rest firmly on the floor. If the treadmill rocks
even slightly, loosen one of the 1/2" Nuts (36),
turn the Leveling Foot clockwise or counter-
clockwise until the rocking motion is eliminated,
and then retighten the Nut.
64
11
12.
Make sure that all parts are properly tightened before you use the treadmill.
If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included. Keep the included hex key in a secure place; the hex key is used
to adjust the walking belt (see page 27).
36
10. Tighten two #8 x 1/2" Machine Screws (4) into
the bottom of the handrail assembly.
Be careful
not to overtighten the Machine Screws.
See step 9.
Tighten the six #8 x 2 1/4" Machine
Screws (3).
Be careful not to overtighten the
Machine Screws.
10
Handrail
Assembly
4
4
11
3
9
Handrail
Assembly
86
3
9. Remove the packaging from the Handrail Cover
(86).
Attach the Handrail Cover (86) to the handrail
assembly with six #8 x 2 1/4" Machine Screws
(3).
Start all six Machine Screws but do not
tighten them yet. Start the indicated Machine
Screws first.
First
First
All manuals and user guides at all-guides.com
