13
10.
Make sure that all parts are properly tightened before you use the incline trainer.
Keep the included hex
keys in a secure place. One of the hex keys is used to adjust the walking belt (see page 29). To protect the
floor or carpet from damage, place a mat under the incline trainer. To avoid damage to the console, keep the
incline trainer out of direct sunlight.
77
9.
If necessary, move the incline trainer to the
desired location (see HOW TO MOVE THE
INCLINE TRAINER on page 27).
After the incline trainer is placed in the loca-
tion where it will be used, make sure that the
incline trainer rests firmly on the floor. If the
incline trainer rocks even slightly, turn a Leveling
Foot (77) as needed until the rocking motion is
eliminated.
9
8.
Slide the Right Inside Upright Cover (70) against
the lower end of the right Upright (83). Then,
press the Right Outside Upright Cover (71)
against the Right Inside Upright Cover until it
snaps into place.
Make sure that the wires (G)
are not pinched.
Attach the Left Inside Upright Cover (not
shown) and the Left Outside Upright Cover
(not shown) as described above.
Note: There
is not a wire on the left side.
70
71
83
G
8
Summary of Contents for NordicTrack Commercial X11i
Page 5: ...5...
