10
8
Avoid pinching
the wires
16
16
16
4
40
40
44
44
37
38
119
138
8. See the inset drawing. Identify a Handlebar
Cover (40) and the Right Rear Leg Cover (44),
and slide them onto a Handlebar (16) as shown.
Tip: Avoid pinching the wires. Insert the
Handlebar (16) into the right side of the
Upright (4), and attach it with two M10 x 45mm
Bolts (119) and two M10 x 18mm Washers (138).
Tip: Avoid pinching the wires. Press the
Right Rear Leg Cover (44) into the Pivot Covers
A and B (37, 38). Then, press the Handlebar
Cover (40) into place.
Repeat this step on the other side of the
elliptical.
148
143
111
9
9. Attach the Accessory Tray (111) to the
Upright (4) from below with two M4 x 16mm
Screws (143).
Then, attach the Accessory Tray (111) to the
Upright (4) from above with two M4 x 10mm
Screws (148).
4